ParkZone VisionAire BNF Instruction Manual download pdf (Page 8)

1. Slide the wing tube (A) into the fuselage.

CAUTION: DO NOT crush or otherwise damage the wiring when

attaching the wing to the fuselage.

2. Install the left and right wing (B and C) over the wing tube and into the

wing slot of the fuselage while inserting the aileron servo connectors

through the provided holes.

3. Invert the fuselage so the landing gear is facing up. Secure the left and

right wings to the fuselage using the included screws (D).

4. Remove the screw (E) and the receiver cover (F) from the bottom of the

fuselage.

Tip: If needed, use hemostats or pliers to pull the servo connectors into

the fuselage.

5. Connect the aileron servos from the wings to the Y-harness connectors in

the fuselage. The left and right aileron servos can be connected to either

side of the Y-harness.

6. Replace the receiver cover and the screw.

Disassemble in reverse order.

IMPORTANT: Correct operation of the AS3X system requires connection of

both ailerons to the included Y-harness and the AILE channel of the receiver.

1. Carefully apply the included tape (A) to the wing fence base.

2. Align and install the left and right (marked L and R) top and bottom wing

fences (B) into the respective wing slots (C). The bottom fences have

integrated plastic skids, as shown.

If desired, apply a small amount of thin CA (cyanoacrylate adhesive)

to the fences and wings.

Installing the Wings

Installing SFG Technology

Wing Fences

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

ParkZone VisionAire BNF Instruction Manual Page 8