Parkzone PKZ5880 User Manual download pdf (Page 9)

Tip: Turn the clevis clockwise or counterclockwise on the linkage.

• Pull the tube from the clevis to the linkage.

• Carefully spread the clevis and put the clevis pin into the desired

control horn.

• Move the tube to tighten the clevis onto the control horn.

After binding a transmitter to the model receiver, set trims and sub-trims

to 0, then adjust clevises to center the control surfaces.

Fly the model at factory settings before making

changes. For pilots who wish for more control throw,

adjust the position of the linkages on the servo arms

and control horns for increased travel.

Start with the battery all the way forward in the

fuselage and hold the battery in place using a hook

and loop strap. It is easiest to balance the ICON

A5 with the aircraft upright. Make adjustments as

needed to obtain the correct balance (as shown)

before ﬂ ying.

Center of Gravity (CG)

Factory Settings

Installing Clevises on Control Horns and Control Centering

Installing Fuselage Gear Covers (Water takeoff and landing)

1. Cover the nose gear hole with the nose plate

using a screw (A).

2. Install the left and right rear gear covers

(marked L and R) using six screws (B).

NOTICE: When removing or installing the nose

plate, ensure the O-ring is not damaged or lost.

2 X 8mm (1)

2 X 8mm (6)

Ailerons

Arms

Horns

Elevator

Nose Gear

Servo Arm

Rudder

Nose Gear

Steering Clevis

30-35mm

(1.18-1.38 inches) from

leading edge of the wing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

No comments

Parkzone PKZ5880 User Manual Page 9