Parkzone PKZ5880 User Manual download pdf (Page 5)

ENEN

1. Carefully lift the back of the canopy hatch (A) and pull hatch pins from the

holes in the fuselage to remove the hatch.

2. Install ﬂ ight battery (B) all the way to the front of the battery compartment,

making certain that it does not bind on the nose wheel steering.

3. Connect battery connector to the ESC power connector.

4. Make sure the ﬂ ight battery (B) is held tight using a hook and loop strap (C).

5. Install canopy hatch on fuselage. Make sure the magnets on the hatch and

fuselage touch.

CAUTION: Always disconnect the Li-Po battery from the aircraft

receiver when not ﬂ ying to avoid over-discharging the battery. Batteries

discharged to a voltage lower than the lowest approved voltage may be

damaged, resulting in loss of performance and potential ﬁ re when batteries

are charged.

CAUTION: Always keep hands

away from the propeller. When armed,

the motor will turn the propeller in

response to any throttle movement.

BIND PLUG



Binding Procedure Reference Table

1. Read the transmitter instructions for binding to a receiver (location of transmitter’s Bind control).

2. Make sure the transmitter is powered off.

3. Move the transmitter controls to neutral and throttle position to low (including throttle trim).*

4. Install a bind plug in the receiver bind port.

5. Connect the ﬂ ight battery to the ESC.

6. The receiver LED will begin to ﬂ ash rapidly.

7. Power on the transmitter while holding the transmitter bind button or switch. Refer to your

transmitter’s manual for binding button or switch instructions.

8. When the receiver binds to the transmitter, the light on the receiver will be solid and the ESC will

produce three short tones .

9. Remove the bind plug from the bind port.

10. Safely store the bind plug (some owners attach the bind plug to their transmitter using two-part

loops and clips).

11. The receiver should retain the binding instructions received from the transmitter until another

binding is done.

* The throttle will not arm if the transmitter’s throttle control is not at the lowest position. If you encounter problems, follow binding instructions and refer to

the transmitter troubleshooting guide for other instructions. If needed, contact the appropriate Horizon Product Support ofﬁ ce.

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique Identiﬁ er) code of a single speciﬁ c transmitter. You

need to ‘bind’ your chosen Spektrum

™

DSM2

™

/DSMX

technology equipped aircraft transmitter to the receiver for proper operation.

Please visit www.bindnﬂ y.com for a complete list of compatible transmitters.

Transmitter and Receiver Binding

NOTICE: When using a Futaba transmitter with a Spektrum DSM

module, you must reverse the

throttle channel.

Installing Battery

BIND/DATA

THR

AILE

ELEV

RUDD

GEAR

AUX 1

2.4GHz DSM® TECHNOLOGY

6CH SPORT RECEIVER 2048

1 2 3 4 5 6 7 8 9 10 ... 18 19

Comments to this Manuals

No comments

Parkzone PKZ5880 User Manual Page 5

Comments to this Manuals

Related products and manuals for Toys Parkzone PKZ5880