ParkZone Mini Vapor RTF Instruction Manual download pdf (Page 10)

Control Centering

Before ﬁ rst ﬂ ights, or in the event of an

accident, make sure the ﬂ ight control surfaces

are centered. Adjust the linkages mechanically if

the control surfaces are not centered.

Use of the transmitter trims may not correctly

center the aircraft control surfaces due to the

mechanical limits of linear servos.

1. Make sure the control surfaces are neutral

when the transmitter controls and trims are

centered. The transmitter sub-trim must be

set to zero.

2. When needed, use a pair of pliers to carefully

bend the metal of the linkage (see illustration).

3. Make the U-shape narrower to make the

connector shorter. Make the U-shape wider

to make the linkage longer.

NOTICE: When using a programmable transmitter,

do not use Sub-Trim to adjust the center position

of the servo.

NOTICE: Never set Travel Adjust above 100%. Ultra

Micro servos are unique in that they are calibrated

to reach maximum travel at 100% travel adjust.

Increasing the value above 100% will NOT result

in more travel, but can cause the servo to lock and

will result in a crash.

Settings for Control Horns

The illustration shows factory settings for linkages

on the control horns. After ﬂ ying, if you want to

modify control throw, carefully adjust the linkage

positions for desired control response.

Rudder Elevator

The transmitter included with the Mini Vapor is the

same transmitter included in other ParkZone Ultra

Micro RTF models.

1. Ensure the battery is disconnected from

the aircraft and the transmitter is turned OFF.

2. Press and hold the digital trim button for

the surface you would like to reverse.

3. While holding the digital trim button, turn

the transmitter ON.

4. Hold the digital trim buttons down for

approximately 5 seconds until you hear a

tone conﬁ rming the selection.

5. Connect the ﬂ ight battery and complete

the ﬂ ight control test. Conﬁ rm all surfaces

operate in the correct direction.

Reverse Controls

Rudder Reversed

Rudder Normal

Elevator Reversed

Elevator Normal

NOTICE: The Mini Vapor RTF should not require any servo reversing. Should the Mini Vapor electronic

components be used in another aircraft, you may ﬁ nd it necessary to reverse the operation of the ﬂ ight

control surfaces.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comments to this Manuals

No comments

ParkZone Mini Vapor RTF Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Remote controlled toys ParkZone Mini Vapor RTF