ParkZone Ka8 2.25M Sailplane PNP Instruction Manual download pdf (Page 8)

Factory Settings

Horns Arms

Elevator

Rudder

Ailerons

Spoilers

Control Horn and Servo Arm Settings

More control throw Less control throw

1. Install the horizontal tail (A) in the slot (B) in the vertical tail. Ensure the

elevator control horn faces down.

2. Secure the horizontal tail on the fuselage using a screw (C).

3. Attach the clevis to the elevator control horn (see instructions for clevis

connection).

When needed, disassemble in reverse order.

Clevis Installation

• Turn the clevis on the linkage to change the length of the linkage

between the servo arm and the control horn.

• Pull the tube from the clevis to the linkage.

• Carefully spread the clevis, then insert the clevis pin into the desired

hole in the control horn.

• Move the tube to hold the clevis on the control horn.

After binding a transmitter to the aircraft receiver, set the trims and

sub-trims to 0, then adjust the clevises to center the control surfaces.

Horizontal Tail Installation

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

After ﬂ ying, you may choose to adjust the linkage positions for the desired

control response. See the table below.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

ParkZone Ka8 2.25M Sailplane PNP Instruction Manual Page 8