ParkZone Ka8 2.25M Sailplane PNP Instruction Manual download pdf (Page 14)

Servoless Tow Release Installation

OPTIONAL

(EFLA405, sold separately)

1. Remove the battery hatch from the fuselage using the latch button.

2. Under the fuselage, remove 2 screws (A) and the cover (B) from the nose.

3. Insert the connector of the servoless payload release (C) in the hole in the

fuselage.

4. Install the optional servoless payload release (D) in the fuselage using

2 screws (E) as shown.

5. Install the cover on the nose of the fuselage using 2 screws.

6. Use a pair of hemostats or needle nose pliers to pull the release connector

from the nose up to the receiver.

7. Insert the connector in an open channel of the receiver (GEAR is

recommended for most transmitters).

When needed, disassemble in reverse order.

Tow Line Connection

1. Pull back the lever (F) on the side of the payload release to retract the pin

(G). A small tool, such as a piece of wire may, be needed to pull back the

lever.

2. Install the loop (H) of the tow line around the pin, then release the lever.

3. Ensure the pin is fully engaged to hold the tow line.

Tip: Before towing, use your transmitter switch to connect and release

a tow line.

NOTICE: DO NOT attempt to launch your Ka-8 using a High-Start connected to

the tow release or a tow line connected to the High-Start hook. Incorrect use of

connections can result in loss of control and damage to the aircraft.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

ParkZone Ka8 2.25M Sailplane PNP Instruction Manual Page 14