Parkzone PKZ5780 User Manual

Spitfire Mk IX Instruction Manual • Bedienungsanleitung • Manuel d’utilisation • Manuale di Istruzioni

ENDisassembly 1. Remove screw (A) and nose cone (B) from spinner nut (C). 2. Use a tool to remove the spinner nut. 3. Remove propeller (D), nose

ENAlways decrease throttle atpropeller strike.Range Check your Radio SystemAfter fi nal assembly, range check the radio system with the Spitfi re Mk IX.

ENPlease see your local or regional modeling association’s guidelines for proper, safe operation of your model aircraft.Effective January 1, 2011A. GE

ENProblem Possible Cause SolutionAircraft will not respond to throttle but responds to other controlsThrottle is not at idle and/or throttle trim is t

ENWhat this Warranty CoversHorizon Hobby, Inc. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free

ENDeclaration of Conformity (in accordance with ISO/IEC 17050-1) No. HH2011071503Product(s): Spitfi re Mk IX BNF Item Number(s): PKZ5780Equipme

Part # | NummerNuméro | CodiceDescription Beschreibung Description DescrizionePKZ1012Propeller “9.5 X 7.5” Luftschraube 9.5x7.5 Hélice 9.5X7.5 Elica

Part # | NummerNuméro | CodiceDescription Beschreibung Description DescrizioneEFLG10010 - 15 Main Electric Retracts E-fl ite 10 bis 15 elektr. Hauptfah

© 2011 Horizon Hobby, Inc.ParkZone, JR, DSMX, DSM2, ModelMatch, Bind-N-Fly, Z-Foam and Plug-N-Play are trademarks or registered trademarks of Horizon

ENENAdditional Safety Precautions and WarningsAs the user of this product, you are solely responsible for operating in a manner that does not endanger

ENENTo register your product online, visit www.parkzone.comThank you for purchasing the ParkZone® Spitfi re Mk IX. You are just minutes away from one o

ENENCharging the Flight BatteryThe Battery Charging Process1. Charge only batteries that are cool to the touch and are not damaged. Look at the batte

ENEN1. Carefully lift the back of battery hatch (A) and pull hatch pins from the holes in the fuselage to remove hatch. 2. Install fl ight battery (B)

EN1. Where installed, remove battery hatch from fuselage.2. Turn aircraft over so the bottom of the fuselage faces up.3. Put the wing’s guide pi

EN1. Install cannons on the front of the wings using two screws (A) for each cannon. 2. Install antenna in slot on top of the fuselage behind the ca

ENTip: Turn the clevis clockwise or counterclockwise on the linkage. • Pull the tube from the clevis to the linkage.• Carefully spread the clevis an

ENElevatorENBind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure the aircraft control surfac