ParkZone Habu 2 EDF Instruction Manual

Habu 2 Instruction Manual • Bedienungsanleitung • Manuel d’utilisation • Manuale di Istruzioni

EN1. Loosely align the horizontal stabilizer unit (A) on the rear of the fuselage. 2. Correctly connect the rudder and elevator servo connectors t

ENTip: Turn the clevis clockwise or counterclockwise on the linkage. • Pull the tube from the clevis to the linkage.• Carefully spread the clevis an

ENElevatorBind your aircraft and transmitter before performing these tests. Move the controls on the transmitter to ensure the aircraft control surfac

ENDisassembly CAUTION: Always disconnect the fl ight battery before performingmotor service. 1. Remove the wing, disconnecting servos as needed. 2.

ENRange Check your Radio SystemAfter fi nal assembly, range check the radio system with the Habu 2. Refer to your specifi c transmitter instruction manu

ENPlease see your local or regional modeling association’s guidelines for proper, safe operation of your model aircraft.Effective January 1, 2011A. GE

ENTroubleshooting GuideProblem Possible Cause SolutionAircraft will not respond to throttle but responds to other controlsThrottle is not set to lowes

ENWhat this Warranty CoversHorizon Hobby, Inc. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free

ENDeclaration of Conformity(in accordance with ISO/IEC 17050-1) No. HH2012032902Product(s): Habu 2 BNF Basic Item Number(s): PKZ7150Equipment

© 2012 Horizon Hobby, Inc.ParkZone, Delta-V, DSM, DSM2, ModelMatch, Bind-N-Fly, EC3 and Z-Foam are trademarks or registered trademarks of Horizon Hobb

EN ENAge Recommendation: Not for children under 14 years. This is not a toy. Safety Precautions and WarningsAs the user of this product, you are solel

ENENTo register your product online, visit www.parkzone.comYou are about to take fl ight with one of the hottest electric ducted fans ever built. Its p

ENWhen a Li-Po battery is discharged below 3V per cell, it will not hold a charge. The ESC protects the fl ight battery from over-discharge using Low V

ENIf you plan on installing optional fl aps or retracts, you must do so before installing the wing. Please proceed to the following pages for instructi

ENInstalling Optional Flaps1. Install the left and right fl ap servos (A) (PKZ1081 x 2, sold separately) in the wing pocket using hot glue or double-

ENInstalling Retractable Nose Gear1. Install the retract harness in the fuselage by connecting the harness to the 3 gear extensions and the GEAR por

ENInstalling the E-fl ite Optional Retractable Landing Gear (Continued)FBCDG2.25 in (57.2mm)AEKHIJ1. Measure and mark 2.25 inches (57.2mm) below the c

ENNose Gear Installation1. Insert the nose strut (A) into the post in the nose gear plate (B) while aligning the fl at spot on the strut with the set